19 Troubleshooting
19.2 Error Messages
320
GC-2010 Plus
19.2.3 Optional device error (AOC-20i/s)
One of the these messages appear when an error has occurred in the AOC-20i auto injector
or the AOC-20s auto sampler.
For details, refer to the AOC-20 User’s Manual.
19.2.4 Communication errors
External device communication error (i.e., Chromatopac)
One of these messages appear during a link failure or communication failure. (When a
communication error occurs, the link is automatically disconnected.)
When one of these messages appear, check the connection status, and reset the link.
Code Message CS Note
6001, 6023 AOCm rack error No
m=1-2
1: Main AOC,
2: SUB AOC
6002, 6024 AOCm syringe error No
6003, 6025 AOCm plunger error No
6004, 6026 AOCm can not start No
6005, 6027 AOCm RAM initialized No
6006, 6028 AOCm ROM error No
6007, 6029 AOCm CH2 command error No
6008, 6030 AOCm sample vial is not set No
6009, 6031 AOCm RAM error No
6010, 6032 AOCm installation error No
6011, 6033 AOCm CH1 error No
6012, 6034 AOCm CH2 error No
6013, 6035 AOCm waste vial is not set No
6014 AOC-20s rotating error No
6015 AOC-20s exp. and ctrl. Error No
6016 AOC-20s up/down error No
6017 AOC-20s can not start No
6018 AOC-20s vial setting error No
6019 AOC-20s vial returning error No
6020 AOC-20s holding error No
6021 AOC-20s sample vial removed No
6022 AOC-20s vial is not set No
Code Message CS Note
4001 Time out No
4002 Parity error No
4003 Message is not accepted No
4004 Data is invalid No
4005 Command is invalid No
4006 Data is out of range No
4007 TRS port is shut down No
4008 TRS file error No
To Next Page
Loading...
Need help?
General
