Shimadzu GC-2010 Plus - PF Menu

7 Starting and Stopping the GC [SYSTEM]
7.2 Specifying Clean Up Parameters
77
GC-2010 Plus
7.2.3 PF menu
PF menu Description
Reference
section
Temp Prog Sets the column oven temperature for the clean up program. 11.2
Press Prog Sets the column inlet pressure for the clean up program. 12.5.5
Flow Prog Sets the total flow rate for the clean up program. 12.5.6
Run
Displayed only while GC is in system ON state. Immediately runs the clean
up program.
――
Stop
Stops clean up.
This item is displayed only when the clean up program is in progress.
――
Next Line Displays the clean up program set up screen for another analytical flow line.
――