14 Diagnosis
14.6
14.
196
GC-2010 Plus
14.6Peak Generator
Select “6. PEAK GENERATOR” to generate electronic peaks to confirm of the operation of the
data processing unit.
14.6.1 Screen description
Select “6. PEAK GENERATOR” from the [DIAG] key screen to display the Peak generator
screen shown in Fig. 14.6.1.
14.6.2 Parameter list
PEAK GENERATOR
Range: On/Off, Default: Off
MODE
Range: Noise/No Noise/Trunc, Default: Noise
Ch1−Ch4 STANDARD SIGNAL
Range: On/Off, Default: Off
14.6.3 PF menu
Fig. 14.6.1 Peak generator setup screen
PF menu Description
Reference
section
Peak Info
Specify the parameters (retention time, full width at half height and peak
height) of the peaks to be generated.
――
To Next Page
Loading...
