Shimadzu GC-2010 Plus - Entering Numeric Values; Changing a Selection

5 Basic Key Operation
5.3 Basic Key Operations
60
GC-2010 Plus
5.3.3 Entering numeric values
Enter a numeric value using the following procedure:
(1) Move the cursor to an item to be set.
(2) Use the numeric keys to enter a number.
(3) Press the [ENTER] key to validate the input.
NOTE The value becomes valid when the [ENTER] key is pressed.
If you move the cursor or display another screen before pressing the [ENTER] key, the value is
deleted.
To clear a value before pressing the [ENTER] key, press the [CE] key.
5.3.4 Changing a selection
Parameters marked with “ ” and “ ” are changed by making another selection. Change
the selection using the following procedure.
(1) Move the cursor to the item.
(2) Select a desired choice by pressing the [ ] and [ ] key.
(3) Press the [ENTER] key to validate the selection.
NOTE The selection change becomes valid when the [ENTER] key is pressed.
If you move the cursor or display another screen before pressing the [ENTER] key, the change is not
made.
To clean the selection before pressing the [ENTER] key, press the [CE] key.
Fig. 5.3.4
△
△
△
△
Change the selection by
pressing the [ ] and [ ] key.
In this example, the selection
changes in this order:
On → Off → On ...
Press the [ENTER] key to
validate the selection.
△
△