19 Troubleshooting
19.2
19.
317
GC-2010 Plus
19.2Error Messages
The system is programmed to diagnosis certain errors. When an error is detected, an alarm
sounds and one of the error messages shown below is displayed. The detected errors are
recorded in the “Error Log”.
When confirmation screens are shown select one of the following actions:
The codes provided with the errors help the service representative identify the errors.
Provide the code when calling about an error. These codes are also recorded in the error log.
NOTE When the system cannot be started due to an abnormality in the ROM, the messages below are
displayed. The error does not have any error code.
When these messages are displayed, the system cannot be used. Turn off the power of the system
and contact your Shimadzu representative.
19.2.1 System errors
Power supply failure
PCB failure
A/D converter failure
Reset Error
Resets the system parameters, restoring the conditions prior to the
error. System control resumes. Remove the cause of the error before
selecting “reset”.
Ignore Error Keep the system as it is. Check for the error to resolve it.
Rom Error Please call a service person.
Rom Error (Fatal) Please call a service person.
Code Message CS Note
1 DC 5 V is out of range No
2 DC 24 V is out of range No
3 DC -15 V is out of range No
4 DC 24 V (FTD) is out of range No
Code Message CS Note
7-10 DET#n PCB error No n=1-4
11-12 CARm AFC PCB error No m=1-2
13-16 Det APCn PCB error No n=1-4
17-19 CARx AMC PCB error No x=1-3
20-22 CARx WBI PCB error No x=1-3
23-28 APC a-b PCB error No
a-b= 1-3, 4-6, 7-9, 10-12,
13-15, 16-18
Code Message CS Note
30 COL A/D conv. error No
31 INJ1 - DET2 A/D error No
32 AUX1 - AUX3 A/D error No
To Next Page
Loading...
