Parameters
List of Parameters
1-140
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Bit parameter for checking and monitoring states during search, if V/f control mode is selected (P1300 < 20).
Description: Bit parameter for checking status of flying start performed with n-adaption of observer.
Parameter is only valid, if sensorless vector control (SLVC)) is selected (P1300 = 20, 22).
r1204 Status word: Flying start V/f / Stat: Flystart V/f
Access level: 4 P-Group: - Data type: Unsigned16
Unit: - Data set: -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Current applied Yes No -
01 Current could not be applied Yes No -
02 Voltage reduced Yes No -
03 Slope-filter started Yes No -
04 Current less threshold Yes No -
05 Current-minimum Yes No -
07 Speed could not be found Yes No -
r1205 Status word: Flying start SLVC / Stat Flystart SLVC
Access level: 3 P-Group: - Data type: Unsigned16
Unit: - Data set: -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Transformation active Yes No -
01 Initialize n-adaption Yes No -
02 Current applying Yes No -
03 n-controller closed Yes No -
04 Isd-controller open Yes No -
05 RFG hold Yes No -
06 n-adaption set to zero Yes No -
07 reserved Yes No -
08 reserved Yes No -
09 reserved Yes No -
10 Direction Positive Yes No -
11 Search is started Yes No -
12 Current is applied Yes No -
13 Search is aborted Yes No -
14 Deviation is zero Yes No -
15 n-controller is active Yes No -
To Next Page
Loading...
Need help?
General
