Siemens CU240S DP-F - Functions; BICO Technology; Data Sets; Digital inputs (DI)

Parameters
Introduction to Parameters
1-8
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
1.1 Introduction to Parameters
The layout of the parameter description is as follows.
leseparameter.pdf
Fig. 1-1 Read-only parameter
schreibparameter.pdf
Fig. 1-2 Write parameter
Parameter number
Indicates the relevant parameter number. The numbers used are 4-digit numbers
in the range 0000 to 9999. Only for PROFINET there are a few parameters in the
range of 61.000. Numbers prefixed with an “r” indicate that the parameter is a
“read-only” parameter, which displays a particular value but cannot be changed
directly by specifying a different value via this parameter number.
All other parameters are prefixed with a “P”. The values of these parameters can
be changed directly in the range indicated by the “Min” and “Max” settings in the
header. If these values have a physical unit, it is shown in brackets.
[index] indicates that the parameter is an indexed parameter and specifies the
range of indices available.
.0...15 indicates that the parameter has several bits, which can be evaluated or
connected individually.
%,&2LIH[LVW
&86
&2$GGLWLRQDOWRUTXHVHWSRLQW&2$GGWUTVHW
$FFHVVOHYHO 3*URXS&ORVHGORRSFRQWURO
8QLW'DWDVHW''6
'DWDW\SH)ORDWLQJ3RLQW
U
U

%,&2LIH[LVW
&86'3
&86'3)
6HOFWLRQRIFRPPDQGVRXUFH&RPPDQGVRXUFHVH
$FFHVVOHYHO
4XLFNFRPP12
&DQEHFKDQJHG7
0LQ

3*URXS&RPPDQGV
$FWLYH<(6
8QLW
0D[

'DWDW\SH8QVLJQHG
'DWDVHW&'6
)DFWRU\VHWWLQJ

3>@
3>@
,QGH[
&830YDULDQWV
