Siemens CU240S DP-F Parameter Manual

List of Parameters
Parameters
1-93
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Transfers values from External to drive when none 0.
Parameter P0010 must be set to 30 for this to be possible.
Values: 0: Disabled
1: Start OP Transfer
Note: Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
Description: Transfers values from External to drive when none 0.
Parameter P0010 must be set to 30 for this to be possible.
Values: 0: Disabled
1: Start OP Transfer
2: Start MMC Transfer
Note: Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
Description: Select clone file to up/down load.
if P0804 = 0 then file name is clone00.bin
if P0804 = 1 then file name is clone01.bin
etc.
Description: Binector input to lock control panel access through external client.
p0803 Transfer data to EEPROM / Transf.Ext->Drive
CU240E Access level: 3 P-Group: Factory settings Data type: Unsigned16
Quick comm. NO Active: NO Data set: -
Can be changed: -
Min Max Factory setting
0 1 0
p0803 Transfer data to EEPROM / Transf.Ext->Drive
CU240S
CU240S DP
CU240S DP-F
CU240S PN
Access level: 3 P-Group: Factory settings Data type: Unsigned16
Quick comm. NO Active: NO Data set: -
Can be changed: -
Min Max Factory setting
0 2 0
p0804 Select Clone file / Select Clone file
CU240S
CU240S DP
CU240S DP-F
CU240S PN
Access level: 3 P-Group: Factory settings Data type: Unsigned16
Quick comm. NO Active: NO Data set: -
Can be changed: -
Min Max Factory setting
0 99 0
p0806 BI: Inhibit panel access / Inhibit panel acce
Access level: 3 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: YES Data set: -
Can be changed: U, T
Min Max Factory setting
- - 0

Siemens CU240S DP-F Specifications

General

Brand	Siemens
Model	CU240S DP-F
Category	Control Unit
Language	English