List of Parameters
Parameters
1-177
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Sets time constant of PT1 filter to smooth flux setpoint.
Description: Displays smoothed flux setpoint in [%] relative to rated motor flux.
Description: Sets the integral time of the field weakening controller.
Description: Displays output signal of field weakening controller in [%] relative to rated motor flux.
Description: Displays total flux setpoint in [%] relative to the rated motor flux.
p1582[0...2] Smooth time for flux setpoint / Flux setp. Tsmooth
Access level: 3 P-Group: Closed-loop control Data type: Unsigned16
Quick comm. NO Active: YES Data set: DDS
Can be changed: U, T
Min Max Factory setting
4 [ms] 500 [ms] 15 [ms]
r1583 CO: Flux setpoint (smoothed) / Smoothed setp.
Access level: 4 P-Group: Closed-loop control Data type: Floating Point
Unit: [%] Data set: -
p1596[0...2] Int. time field weak. controller / Int.time weak.ctrl
Access level: 3 P-Group: Closed-loop control Data type: Unsigned16
Quick comm. NO Active: YES Data set: DDS
Can be changed: U, T
Min Max Factory setting
20 [ms] 32001 [ms] 50 [ms]
r1597 CO: Outp. field weak. controller / Outp.weak. ctrl
Access level: 4 P-Group: Closed-loop control Data type: Floating Point
Unit: [%] Data set: -
r1598 CO: Flux setpoint (total) / Total flux setp
Access level: 3 P-Group: Closed-loop control Data type: Floating Point
Unit: [%] Data set: -
To Next Page
Loading...
Need help?
General
