List of Parameters
Parameters
1-31
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Displays actual torque. Output value will be zero at low speeds when current injection is active (r1751.4 = 1). This
value is available filtered (r0031) and unfiltered (r0080).
Description: Displays air gap flux in [%] relative to the rated motor flux.
Description: Displays re-active (imaginary part) of motor current.
Dependency: Applies when V/f control is selected in P1300 (control mode); otherwise, the display shows the value zero.
Description: Displays active (real part) of motor current.
Dependency: Applies when V/f control is selected in P1300 (control mode); otherwise, the display shows the value zero.
Description: Displays the actual power factor.
Description: Indicates the current angle of the rotor.
Description: Displays the transformation angle (flux angle in VC mode or angle from frequency in Vf mode)
r0080 CO: Act. torque / Act. torque
Access level: 4 P-Group: Closed-loop control Data type: Floating Point
Unit: [Nm] Data set: -
r0084 CO: Act. air gap flux / Air gap flux
Access level: 4 P-Group: Closed-loop control Data type: Floating Point
Unit: [%] Data set: -
r0085 CO: Act. re-active current / Act.re-active cur
Access level: 3 P-Group: Closed-loop control Data type: Floating Point
Unit: [A] Data set: -
r0086 CO: Act. active current / Act.active cur
Access level: 3 P-Group: Closed-loop control Data type: Floating Point
Unit: [A] Data set: -
r0087 CO: Act. power factor / Act.power fact
Access level: 3 P-Group: Closed-loop control Data type: Floating Point
Unit: - Data set: -
r0090 CO: Act. rotor angle / Act rotor angle
Access level: 2 P-Group: Closed-loop control Data type: Floating Point
Unit: [°] Data set: -
r0094 CO: Transformation angle / Transf. angle
Access level: 3 P-Group: Closed-loop control Data type: Floating Point
Unit: [°] Data set: -
To Next Page
Loading...
Need help?
General
