Connector/Binector (BICO)-Parameters
Parameters
1-307
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
p2235[0...2] BI: Enable PID-MOP (UP-cmd) / PID-MOP (UP)
p2236[0...2] BI: Enable PID-MOP (DOWN-cmd) / PID-MOP (DWN)
p2241[0...2] BI: PID-MOP select setpoint auto/manu / Setp. auto/manu
p2243[0...2] BI: PID-MOP accept rampgenerator setpoint / PMOP acc RFG setpo
p2480[0...2] BI: Enable positioning ramp down / Enable positioning
p2810[0...1] BI: AND 1 / AND 1
p2812[0...1] BI: AND 2 / AND 2
p2814[0...1] BI: AND 3 / AND 3
p2816[0...1] BI: OR 1 / OR 1
p2818[0...1] BI: OR 2 / OR 2
p2820[0...1] BI: OR 3 / OR 3
p2822[0...1] BI: XOR 1 / XOR 1
p2824[0...1] BI: XOR 2 / XOR 2
p2826[0...1] BI: XOR 3 / XOR 3
p2828 BI: NOT 1 / NOT 1
p2830 BI: NOT 2 / NOT 2
p2832 BI: NOT 3 / NOT 3
p2834[0...3] BI: D-FF 1 / D-FF 1
p2837[0...3] BI: D-FF 2 / D-FF 2
p2840[0...1] BI: RS-FF 1 / RS-FF 1
p2843[0...1] BI: RS-FF 2 / RS-FF 2
p2846[0...1] BI: RS-FF 3 / RS-FF 3
p2849 BI: Timer 1 / Timer 1
p2854 BI: Timer 2 / Timer 2
p2859 BI: Timer 3 / Timer 3
p2864 BI: Timer 4 / Timer 4
p2940 BI: Release Wobble function / Rel Wobble
To Next Page
Loading...
Need help?
General
