Siemens SINAMICS G115D

Setting pump monitoring
1. Set p2193 = 4.
2. The converter sets the monitoring as shown.
,ISU಺WKHQS U಺
,ISุU಺WKHQS SbUSP
6SHHG>USP@
/HDNDJH
'U\UXQQLQJSURWHFWLRQ
RUWRUQEHOW
S SbUSP
%ORFNHG
S SbUSP
7RUTXH>1P@
S U಺
S U಺
S U
S SS
S U಺
S U಺
3. The converter sets monitoring response p2181 = 7
4. If necessary, adjust the speed thresholds p2182 … p2184.
5. If necessary, adjust the torque threshold for each speed.
The converter displays the current torque in r0031.
You have now set monitoring.
❒
Setting fan and compressor monitoring
1. Set p2193 = 5.
2. The converter sets the monitoring as shown.
,ISS಺WKHQS S಺
,ISุS಺WKHQS SbUSP
6SHHG>USP@
'U\UXQQLQJSURWHFWLRQ
RUWRUQEHOW
S SbUSP
%ORFNHG
S SbUSP
7RUTXH>1P@
S U಺
S U
S PLQ
S S S 
3. The converter sets monitoring response p2181 = 7
4. If necessary, adjust the speed thresholds p2182 … p2184.
5. Set the torque threshold for each speed.
The converter displays the current torque in r0031.
Advanced commissioning
7.27Monitoring the driven load
SINAMICS G115D Wall Mounted distributed drive
332 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA