Siemens SINAMICS S210 - Prompt for the Administrator Password; To Assign an Administrator Password

To assign an administrator password, proceed as follows:
1. Switch the converter on and within 10 minutes, connect it via the service interface (X127)
to the web server (default IP address: 169.254.11.22.).
The following screen form only appears when an administrator password has not yet been
assigned and only for 10 minutes after switch-on.
Figure 6-1 Prompt for the administrator password
2. Enter an administrator password in the "Password" field.
Note
To protect against unauthorized access, by an attacker, for example, select a password
that is as secure as possible, and consists of:
● At least 8 characters
● Uppercase and lowercase letters
● Numbers and special characters (e.g.: ?!%+ ...)
It is not permissible that the password is used elsewhere.
Checking the password
The length of the password is checked by the converter. There is no check for uppercase
and lowercase letters and special characters!
3. Repeat the password in the "Confirm password" field.
If the input is not identical in both fields, the "OK" button is not enabled.
Commissioning and diagnostics in the Web server
6.2 First login
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 109