Specification of the motor
By varying, you can find the motor that satisfies the conditions of the operating mode (duty
cycle).
● Determine the motor current at base load. The calculation depends on the type of motor
(synchronous motor or induction motor) and the operating mode (duty cycle) used.
Note
When configuring according to duty cycle with constant ON duration with overload, the
overload current is calculated in relation to the required overload torque.
● Comply with the thermal limits of the motor.
● Configure the other properties of the motor through the available motor options.
Configuring
3.3 Configuring the motor
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 51
To Next Page
Loading...
