Index: [0] = Unsmoothed
[1] = Smoothed with p0045
r0079[0...1] Torque setpoint total
Data type: FloatingPoint32 P group: Displays, signals Scaling: p2003
Description: Display for the torque setpoint at the output of the speed controller.
Index: [0] = Unsmoothed
[1] = Smoothed with p0045
r0080 Torque actual value
Data type: FloatingPoint32 P group: Displays, signals Scaling: p2003
Description: Display for the actual torque.
Dependency: See also: r0031
Note
The value is available smoothed (r0031) and unsmoothed (r0080).
r0082[0...3] Active power actual value
Data type: FloatingPoint32 P group: Displays, signals Scaling: r2004
Description: Displays the actual active power.
Index: [0] = Unsmoothed
[1] = Smoothed with p0045
[2] = Power drawn
[3] = Power drawn smoothed
Dependency: See also: r0032
Note
The mechanical active power is available smoothed (r0032 with 100 ms, r0082[1] with p0045) and unsmoothed
(r0082[0]).
For index [3]:
Smoothing time constant = 4 ms
p0210 Drive unit line supply voltage
Changeable: C2(2), T Data type: Unsigned16 P group: Converter
Min: 1 [V] Max: 63000 [V] Def: 600 [V]
Description: Sets the drive unit supply voltage.
The voltage between two phases should be entered as the device supply voltage.
This setting is important for operating with voltages that are less than the voltage range intended for the drive.
NOTICE
If, in the switched-off state (pulse inhibit), the supply voltage is higher than the entered value, the Vdc controller may
be automatically deactivated in some cases to prevent the motor from accelerating the next time the system is
switched on. In this case, an appropriate alarm A07401 is output.
Parameters
12.2 List of parameters
SINAMICS S210 servo drive system
234 Operating Instructions, 12/2017, A5E41702836B AA
To Next Page
Loading...
