6.12 Saving permanently
The changed settings are only saved in the volatile memory. They are lost when you switch
off the converter or close the Web server. For this reason, it is important that the settings made
in the Web server are regularly saved permanently (also known as "Copy RAM to ROM"). You
can either save the setting for each individual commissioning step or save all the settings made
and the tuning results at the end of the commissioning.
1. To save permanently, click in the footer of the Web server.
A save prompt appears:
Figure 6-37 Permanent saving prompt
2. Click "Save" to save the data permanently.
Commissioning and diagnostics in the Web server
6.12 Saving permanently
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 161
To Next Page
Loading...
