6.9.1.2 Filtering messages
You can set filters in the message list of the Web server and therefore limit the display of the
messages. You can make the filter settings via a filter bar above the message list. All filters
are linked by an AND connection.
Figure 6-31 Filter bar of the message list
Setting filters
1. In the "Search" field, enter a search term (any number of characters) for which you want to
search in the message list.
The search term is also active in the "Alarm" column in the message list.
2. In the two "Filter by Date" fields, enter a period for which the messages are to be displayed.
The message list is limited further after every filter setting. The filters can be set in any
order.
Note
Collapsing the filter bar
The filter bar is opened per default. To collapse the filter bar, click the arrow next to "Search
and Filters".
Resetting filters
As long as you are logged in to the Web server and the filter settings have not changed, the
message list is always displayed with the last filter settings. To reset all filter settings in the
message list, proceed as follows:
Click "Reset all filters" at the top right in the filter bar.
The message list then displays the unfiltered view of the messages again.
Commissioning and diagnostics in the Web server
6.9 Diagnostics in the Web server
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 151
To Next Page
Loading...
