Siemens SINAMICS S210 - Changing the Parameter Value; Filter Bar of the Parameter List; Filtering the Parameter List; Setting the Filters of the Parameter List

6.6.4.2 Changing the parameter value
You can change the parameter values of the parameters that can be written to (p parameters)
in the parameter list.
To do this, you have one of the following options:
1. Overwrite the current parameter value with the new value.
2. Select a value via the drop-down list.
Invalid values will be rejected.
Click
to save the data permanently.
6.6.4.3 Filtering the parameter list
You can set filters in the parameter list of the Web server and therefore limit the display of the
parameters. You can make the filter settings via a filter bar above the parameter list. You can
also combine the individual filter settings.
Figure 6-18 Filter bar of the parameter list
Setting the filters of the parameter list
1. In the "Search" field, enter a search term (any number of characters) for which you want to
search in the parameter list, e.g. "Current".
The search term is applied to the "ID" (only in the advanced view) and "Parameter" columns
in the parameter list.
2. Select a group from the "Parameter Group" drop-down list.
– All groups
– My groups (configured by the user)
– Specific groups, such as motor parameters
3. In the "Parameter Types" drop-down list, select whether adjustable parameters ("Editable"),
display parameters ("write protected") - or both are to be displayed in the parameter list.
Commissioning and diagnostics in the Web server
6.6 Settings
SINAMICS S210 servo drive system
132 Operating Instructions, 12/2017, A5E41702836B AA