Siemens SINAMICS S210 - Checking Existing Safety Settings in the Read Mode; Safety Commissioning in Read Mode

6.8.1.8 Checking existing safety settings in the read mode
You can run through the complete safety commissioning step-by-step in the read mode and
check the settings that have been made.
1. Activate the "Read-only mode" option.
Figure 6-28 Safety commissioning in read mode
The individual commissioning steps are displayed in the header of the "Safety
Commissioning" screen form.
2. Click the "Continue" button each time and check the settings that are required Safety
commissioning.
Commissioning and diagnostics in the Web server
6.8 Safety settings
SINAMICS S210 servo drive system
148 Operating Instructions, 12/2017, A5E41702836B AA