6.4 Login/logout
6.4.1 Users and access rights
There are two or permanent defined users for access to the converter via the web server:
● Administrator
The administrator has full access to the converter data displayed in the web server. A
password is always required for access as administrator.
● SINAMICS
The SINAMICS user has restricted access rights, see the following table. Per default, a
password is not assigned for the SINAMICS user.
Note
Configuring passwords for the users
You can configure the passwords of the two users in the system settings with administrator
rights (see Chapter "Setting or changing user accounts (Page 156)").
The following access rights apply for the users of the web server:
Functions of the web server Access rights
SINAMICS Administrator
Start page
Password input
Write Write
Perform commissioning
● Change drive name
● Perform One Button Tuning
● Use control panel
None
1)
Write
Safety settings
● Make commissioning settings
● Check commissioning in read mode
● Diagnostics
None
1)
None
1)
Read
Write
Read
Read
Diagnostics
● Display communication settings
● Adapt message list
● Acknowledge alarms
Write
Write
Write
Write
Write
Write
Settings
● Set limits
● Adapt brake control
● Adapt digital inputs
● Adapt parameter list
● Change parameterization
Read
Read
Read
Write
Read
Write
Write
Write
Write
Write
Commissioning and diagnostics in the Web server
6.4 Login/logout
SINAMICS S210 servo drive system
114 Operating Instructions, 12/2017, A5E41702836B AA
To Next Page
Loading...
