Perform the following steps to configure the user accounts for the web server:
Changing the Administrator password
The "Administrator" cannot be deactivated.
1. To change the Administrator password, click "Change password..." at the "Administrator"
user.
A password dialog opens.
2. Enter the old password.
3. Enter a new password.
4. Enter the new password again.
5. Confirm the password change with "Change".
The dialog closes.
6. Click to save the data permanently.
Defining a new password for the "SINAMICS" user
1. Activate the "Enable SINAMICS user" option.
2. Click "Define password..." at the "SINAMICS" user.
A password dialog opens.
3. Enter a new password.
4. Enter the new password again.
5. Confirm the password input with "OK".
The dialog closes.
6. Click to save the data permanently.
Changing/deleting the password for the "SINAMICS" user
1. If you want to change the password of the "SINAMICS" user, proceed as for the
Administrator password (see "Changing the Administrator password").
- Or -
2. If you want to delete the password of the "SINAMICS" user, click "Delete password...".
A prompt appears.
Enter the old password and click "Delete".
3. Click to save the data permanently.
Commissioning and diagnostics in the Web server
6.11 System settings
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 157
To Next Page
Loading...
