You can also connect quick-connection cables with SPEED-CONNECT to motor connectors
as conventional cables with screw locks (fully threaded).
Note
We recommend cables equipped with SPEED-CONNECT connectors.
Handling plug-in connections
The following information on the handling of plug-in connections applies for power connectors
and signal connectors as round connector in the SPEED-CONNECT version and fully threaded.
The figures show the connecting and disconnecting of the power connector in the SPEED-
CONNECT version.
Connecting
Figure 5-7 Connecting the SPEED-CONNECT plug-in connection
1. Make sure that the SIEMENS logo on the connector enclosure is at the top or that the
arrows on both connectors are opposite to each other. This ensures that the pins and coding
keys of the connector and motor connector are aligned.
2. Push the connector into the motor connector up to the endstop.
3. Tighten the fastener or the screw cap per hand in a clockwise direction.
Disconnecting
Figure 5-8 Disconnecting the SPEED-CONNECT plug-in connection
1. Turn the fastener or the screw cap per hand in an anticlockwise direction up to the endstop.
2. Pull the connector out of the motor connector.
Note
To disconnect the plug-in connection, always pull the cable connector and not the cable.
Installing
5.4 Connecting the converter and the motor
SINAMICS S210 servo drive system
92 Operating Instructions, 12/2017, A5E41702836B AA
To Next Page
Loading...
