Siemens SINAMICS S210 - Connections at the Converter; Connections and Operator Controls on the Converter; Overview of Connections and Operator Controls on the Converter

5.4.3.1 Connections at the converter
Connections and operator controls on the converter
(UURUGLVSOD\
6ORWIRU6'FDUG
6WDWXV/('V
;
6HUYLFHLQWHUIDFH(WKHUQHW
;
3UREHDQG
IDLOVDIH
GLJLWDOLQSXW
;3
352),1(7SRUW
;3
352),1(7SRUW
;
(QFRGHUFRQQHFWLRQ
;
0RWRUKROGLQJEUDNH
$FNQRZOHGJHHUURU
;
9H[WHUQDO
GDLV\FKDLQIRUDGGLWLRQDO
FRQYHUWHUV
;
/LQHFRQQHFWLRQDQG
H[WHUQDOEUDNLQJUHVLVWRU
;
0RWRUFRQQHFWLRQ
6KLHOGFRQQHFWLRQIRU
VKLHOGHGFDEOHV
FDEOHUHOLHIYLDFDEOHWLHIRU
RWKHUFDEOHV
Figure 5-10 Overview of connections and operator controls on the converter
Type of connection Connector
Control voltage 24 VDC X124 Included in the scope of sup‐
ply
Line connection and external braking resistor X1 Included in the scope of sup‐
ply
Motor power connections X2 Included in the scope of sup‐
ply
Service interface X127 RJ45
Digital inputs X130 Included in the scope of sup‐
ply
Connection to the control system via PROFINET X150 P1
X150 P2
RJ45
Installing
5.4 Connecting the converter and the motor
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 95