4. Assign a safety password. You can also define the safety password later. As long as a
safety password is not defined, the drive issues an alarm.
Configuring the safety password (Page 146)
5. If a safety password has been defined, enter the safety password in the input field.
You cannot make any further Safety settings without this entry.
6. To start the configuration of the individual Safety commissioning steps, click "Start" in the
footer of the screen form.
Commissioning and diagnostics in the Web server
6.8 Safety settings
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 139
To Next Page
Loading...
