Siemens SITRANS F - Page 146

Setup
3.4 Inputs and outputs
FST030
144 Function Manual, 04/2017, A5E35693328-AA
3.4.5.8.2 Sensor alarms (1)
Description
Selection of alarm items that impact the output. Mainly sensor alarms. Applicable if Status
mode = Alarm item.
Setting
05 DSL voltages; 06 DSL Storage; 07 Flow measurement; 08 DSL internal; 09 Oil Density;
10 Oil Viscosity; 11 Oil spec. gravity; 14 Path 1: No signal; 15 Path 2: No signal; 16 Path 3:
No signal; 17 Path 4: No signal; 19 Electronics temp.; 22 Density calculation; 23 Medium
temp. calc.; 24 Pressure calculation; 25 Viscosity calculation; 26 Sensor temp. comp.; 28
Configuration 1
Default
None
Related
Path
Setup → Inputs and outputs → Channel 3 - input/output → Status output → Sensor alarms
(1)
3.4.5.8.3 Sensor alarms (2)
Description
Selection of alarm items that impact the output. Mainly sensor alarms. Applicable if Status
mode = Alarm item.
Setting
32 Auxiliary input; 34 Invalid flow meas.; 35 Failure on CH5 or CH6; 36 Configuration 2; 37
DSL system monitor
Default
None
Related
Path
Setup → Inputs and outputs → Channel 3 - input/output → Status output → Sensor alarms
(2)
3.4.5.8.4 Process alarms (1)
Description
Selection of alarm items that impact the output. Applicale if Stats mode = Alarm item.
Setting
96 Mass flow above alarm limit; 97 Mass flow above warning limit; 98 Mass flow below
warning limit; 99 Mass flow below alarm limit; 100 Volume flow above alarm limit; 101 Vol-
ume flow above warning limit; 102 Volume flow below warning limit; 103 Volume flow be-
low alarm limit; 104 Density above alarm limit; 105 Density above warning limit; 106
Density below warning limit; 107 Density below alarm limit; 108 Medium temp. above alarm
limit; 109 Medium temp. above warning limit; 110 Medium temp. below warning limit; 111
Medium temp. below alarm limit
Default
None