Q
UALITY
OF
S
ERVICE
3-223
• Exceed Action – Specifies whether the traffic that exceeds the
specified rate will be dropped or the DSCP service level will be
reduced.
• Remove Class – Deletes a class.
- Policy Options -
• Class Name – Name of class map.
• Action – Configures the service provided to ingress traffic by setting
a CoS, DSCP, or IP Precedence value in a matching packet (as specified
in Match Class Settings on page 3-216). (Range - CoS: 0-7, DSCP: 0-63,
IP Precedence: 0-7, IPv6 DSCP: 0-63)
• Meter – Check this to define the maximum throughput, burst rate, and
the action that results from a policy violation.
- Rate (kbps) – Rate in kilobits per second. (Range: 1-100000 kbps or
maximum port speed, whichever is lower)
- Burst (byte) – Burst in bytes. (Range: 64-1522)
• Exceed – Specifies whether the traffic that exceeds the specified rate
or burst will be dropped or the DSCP service level will be reduced.
- Set – Decreases DSCP priority for out of conformance traffic.
(Range: 0-63).
- Drop – Drops out of conformance traffic.
• Add – Adds the specified criteria to the policy map.
Web – Click QoS, DiffServ, Policy Map to display the list of existing policy
maps. To add a new policy map click Add Policy. To configure the policy
rule settings click Edit Classes.
To Next Page
Loading...
