EasyManuals Logo

SMC Networks TigerSwitch SMC6128PL2 User Manual

SMC Networks TigerSwitch SMC6128PL2
658 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #283 background imageLoading...
Page #283 background image
M
ULTICAST
F
ILTERING
3-229
• IGMP Query Count — Sets the maximum number of queries issued
for which there has been no response before the switch takes action to
drop a client from the multicast group. (Range: 2-10; Default: 2)
• IGMP Query Interval — Sets the frequency at which the switch
sends IGMP host-query messages. (Range: 60-125 seconds; Default:
125)
• IGMP Report Delay — Sets the time between receiving an IGMP
Report for an IP multicast address on a port before the switch sends
an IGMP Query out of that port and removes the entry from its list.
(Range: 5-25 seconds; Default: 10)
• IGMP Query Timeout — The time the switch waits after the
previous querier stops before it considers the router port (i.e., the
interface which had been receiving query packets) to have expired.
(Range: 300-500 seconds; Default: 300)
• IGMP Version — Sets the protocol version for compatibility with
other devices on the network. (Range: 1-2; Default: 2)
Notes: 1. All systems on the subnet must support the same version.
2. Some attributes are only enabled for IGMPv2, including
IGMP Report Delay and IGMP Query Timeout.
Web – Click IGMP Snooping, IGMP Configuration. Adjust the IGMP
settings as required, and then click Apply. (The default settings are shown
below.)

Table of Contents

Other manuals for SMC Networks TigerSwitch SMC6128PL2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SMC Networks TigerSwitch SMC6128PL2 and is the answer not in the manual?

SMC Networks TigerSwitch SMC6128PL2 Specifications

General IconGeneral
BrandSMC Networks
ModelTigerSwitch SMC6128PL2
CategorySwitch
LanguageEnglish

Related product manuals