F
LASH
/F
ILE
C
OMMANDS
4-95
Example
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description of the
file information displayed by this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
- boot-rom* - Boot ROM.
- config* - Configuration file.
- opcode* - Run-time operation code.
- filename - Name of the configuration file or code image.
- unit* - Specifies the unit number. (Always unit 1)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Console#whichboot
file name file type startup size
(byte)
------------------------------------- -------------- -------
-----------
Unit1:
D2218 Boot-Rom image Y
214124
V2271 Operation Code Y
1761944
Factory_Default_Config.cfg Config File Y
5197
Console#
To Next Page
Loading...
Need help?
General
