M
ULTICAST
F
ILTERING
C
OMMANDS
4-289
The following shows information about the interfaces associated with
multicast groups assigned to the MVR VLAN:
show mvr interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for
source ports is “ACTIVE” if MVR is globally enabled on the
switch. MVR status for receiver ports is “ACTIVE” only if
there are subscribers receiving multicast traffic from one of the
MVR groups, or a multicast group has been statically assigned
to an interface.
Immediate
Leave
Shows if immediate leave is enabled or disabled.
Console#show mvr members
MVR Group IP Status Members
---------------- -------- -------
225.0.0.1 ACTIVE eth1/1(d), eth1/2(s)
225.0.0.2 INACTIVE None
225.0.0.3 INACTIVE None
225.0.0.4 INACTIVE None
225.0.0.5 INACTIVE None
225.0.0.6 INACTIVE None
225.0.0.7 INACTIVE None
225.0.0.8 INACTIVE None
225.0.0.9 INACTIVE None
225.0.0.10 INACTIVE None
Console#
show mvr members - display description
Field Description
MVR Group
IP
Multicast groups assigned to the MVR VLAN.
Status Shows whether or not the there are active subscribers for this
multicast group. Note that this field will also display “INACTIVE”
if MVR is globally disabled.
Members Shows the interfaces with subscribers for multicast services
provided through the MVR VLAN. Also shows if an interface has
dynamically joined a multicast group (d), or if a multicast group has
been statically bound to the interface (s).
To Next Page
Loading...
Need help?
General
