Setup Menu
Pocket-3D Reference Guide
2-60
Figure 2-81. Import Alignment Files
3. On the import alignment files To: dialog box, highlight a file to
select it and press Next (
Figure 2-81).
4. On the import alignment file dialog box (Figure 2-82), do the
following:
• Import into recipients current active project – check mark this
box to import surface files into your project.
• Overwrite surface w.same name – check mark this box to
overwrite duplicate filenames.
• Next – press to display the Send dialog box (Figure 2-82).
Figure 2-82. Import an Alignment File
•On the Send dialog box, press Finish to save and return to the
Main Screen (
Figure 2-82 on page 2-60).
To Next Page
Loading...
