Topcon Pocket-3D - Polyline from Points

Data Menu
Pocket-3D Reference Guide
3-98
Figure 3-147. Point Properties
Polyline From Points
On the Calculation type dialog box, select Polyline from points, then
press Next (
Figure 3-148).
Figure 3-148. Calculation Type – Polyline From Points
This process creates a polyline from the points selected on the main
screen.
The view screen displays the polyline created from the selected points
(
Figure 3-149 on page 3-99). Press the +/- buttons to zoom in or out
on the image or press down on the screen to drag the image round.
Press Next to continue.