Topcon Pocket-3D - Control Point

Measure Points
P/N 7010-0628
4-5
Control Point
To measure a point that can be used as a mmGPS transmitter location
point, tap Survey
Measure ptsControl pt (Figure 4-8).
Figure 4-8. Measure a Control Point
On the control pt dialog box (Figure 4-9 on page 4-6), enter the
following information, then press start to measure Coords/GPS
coordinates.
• Name – enter a name for the control point.
• Description – enter the point description (if preferred).
NOTICE
The measure control points option is used to add
mmGPS transmitter location points. Do not use for
extending localization.