Topcon Pocket-3D - Page 288

Survey Menu
Pocket-3D Reference Guide
4-62
will automatically zoom in to get a closer look. The scale bar will
turn red to indicate that Pocket-3D zoomed in or out.
• Show deltas to target from – select the target from which to show
deltas.
– Prism: shows the deltas from the prism during a
measurement.
– Instrument: shows the deltas from the instrument during a
measurement.
• Show following details for – select the desired details to show on
the main screen during a stake-out.
– Dist, Azimuth: select to show distance and azimuth
information during a measurement/stake-out.
– Dist, Offset: select to show a distance and offset during a
measurement/stake-out.
– Delta E, Delta N: select to show east/north information during
a measurement/stake-out.
The Cut Sheet tab, select to do the following:
• Enable cut sheets – turns on/off at sheet collection.
• Targeted text file –select the location in which to store the cut
sheet from the drop-down list.
• Append to target file – enable to append the current target file.
• Logging format – select the desired format for the cut sheet from
the drop-down list.
The Audio tab, select to have an internal, Pocket-3D voice recite the
cut/fills value rounded to the nearest tenth of a foot.
• Report cut/fills to surface – enable to audibly report the cuts/fills
to the surface.
• Time interval (secs) – enter the desired time interval in seconds
for the voice to recite the cut/fill.