Topcon Pocket-3D - Page 6

Table of Contents
Pocket-3D Reference Guide
ii
Base Station ............................................................... 2-8
Units ........................................................................... 2-11
Exit ............................................................................. 2-12
Equipment Configuration Files ........................................ 2-13
Sample Configuration 1: Range-pole with 
HiPer Lite Receiver ................................................ 2-13
mmGPS Applications ....................................................... 2-18
Equipment .................................................................. 2-19
mmGPS Transmitters ................................................. 2-19
TX Calibration .................................................... 2-21
Edit Channel ........................................................ 2-23
Benchmark Check ............................................... 2-24
Resection ............................................................. 2-25
mmGPS Receiver ....................................................... 2-27
Total Station Applications ................................................ 2-29
Equipment .................................................................. 2-29
Range-pole ................................................................. 2-31
Sample Configuration 4: Prism and Total Station ..... 2-32
Robotic Applications ........................................................ 2-35
Equipment ........................................................................ 2-36
Station Setup .................................................................... 2-38
SiteLink® 3D for Pocket-3D ........................................... 2-44
The Site-Link Network Connection ........................... 2-45
Connecting to SiteLink-3D .............................................. 2-46
Selecting the Current Operator .................................. 2-47
Managing Activities/Delays ...................................... 2-47
Sending, Viewing, and Deleting Messages ............... 2-48
Send Any File to the Jobsite ...................................... 2-50
Exporting a Project File Via Site-Link ...................... 2-51
Importing/Exporting Control Points Via Site-Link .......... 2-54
Importing/Exporting Surface Files Via Site-Link ............ 2-57
Importing/Exporting Alignment Files Via Site-Link ....... 2-59
Importing/Exporting Linework Files Via Site-Link ......... 2-61
Importing/Exporting Points Via Site-Link ....................... 2-63
Chapter 3
Data Menu ............................................................. 3-1
Project ............................................................................... 3-2