Topcon Pocket-3D - Page 8

Table of Contents
Pocket-3D Reference Guide
iv
Distance From Two End Pts ...................................... 3-89
Convert Polyline to Points ......................................... 3-93
Convert Alignment to Points ..................................... 3-95
Polyline From Points ................................................. 3-98
TIN Surface from Points/Lines .................................. 3-100
Convert TIN Surface to Points .................................. 3-104
Convert Polyline to Alignment .................................. 3-105
Best-fit Plane from Points .......................................... 3-107
Compare Two Surfaces .............................................. 3-108
Move Selected Objects ..................................................... 3-111
Copy Selected Objects ..................................................... 3-113
Clear Selection ................................................................. 3-115
Chapter 4
Survey Menu ........................................................ 4-1
GPS Survey Applications ................................................. 4-1
Connect to GPS/Disconnect from GPS ..................... 4-2
Measure Points ................................................................. 4-2
Topo-shot ................................................................... 4-3
Topo-shot With Offset ............................................... 4-4
Control Point .............................................................. 4-5
Reference Line ........................................................... 4-6
Start Polyline ............................................................. 4-8
Next Polyline Pt ......................................................... 4-9
End Polyline ............................................................... 4-9
Start Tape Dimension ................................................ 4-10
Tape Dimension ......................................................... 4-11
Stop Tape Dimension ................................................ 4-13
Options ....................................................................... 4-13
Auto-topo/Stop Auto-topo ................................................ 4-16
By Distance ................................................................ 4-17
By Time ..................................................................... 4-18
By Elevation .............................................................. 4-19
Polyline ...................................................................... 4-21
Stake-out ........................................................................... 4-22
Surface Check ............................................................ 4-23
Cut/Fill “Real-Time” Updates ............................. 4-24
Match Grade ........................................................ 4-27