Chapter 12 165
Using LAN
Getting Ready for Using LAN
1. Chapter Title
12. Using LAN 3. Chapter Title
4. Chapter Title
5. Chapter Title
Getting Ready for Using LAN
Getting ready for LAN connection
Before connecting the 4294A with LAN, you set an IP address (a unique address within a
single LAN assigned to a device to identify it in making LAN connection), a gateway IP
address (the IP address of a routing device that connects your the 4294A’s LAN with other
LANs), and a sub-net mask (a numerical value used to judge whether your the 4294A
needs to route communications through the gateway).
NOTE Obtain the settings of IP address, gateway address, and sub-net mask from your network
administrator.
NOTE If your network doesn’t need to be connected with devices on different physical networks,
usually you need to set neither the gateway IP address nor the sub-net mask.
NOTE To validate the IP address, the gateway IP address, and the sub-net mask you set, you need
to cycle power of the 4294A (power it off and power it on again).
Setting an IP address
Here follows the way of setting an IP address.
Step 1. Press the [Local] key in the INSTRUMENT STATE block on the front panel, and press the
IP ADRESS key.
Step 2. Press the 1st key, and enter the first number of the IP address delimited by a period.
Step 3. Press the 2nd key, the 3rd key, and the 4th key, and similarly enter the second, the third,
and the fourth numbers of the IP address delimited by a period.
Step 4. Press the done key.
To make settings with the GPIB command, use the command given below.
• “ADDRIP” on page 265
To Next Page
Loading...
Need help?
General
