426 Chapter 16
GPIB Command Reference
SDELT
SDELT
Syntax SDELT <numeric>[S]
SDELT?
Description Sets the delay time for each sweep.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
key
[Sweep] -TIME - SWEEP DELAY
SDON
Syntax SDON
Description In creation/edit of the list sweep table, finishes segment creation/edit. Executing this
command brings the created/edited segment to take effect. (No query)
NOTE Executing the “EDITDONE” command on page 310 brings the created/edited list sweep
table to take effect.
Corresponding
key
[Sweep] - EDIT LIST - EDIT - done
SEAL
Syntax SEAL
Description For the active trace (set with the “TRAC” command on page 457), moves the marker to the
target (set with the “SEATARG” command on page 433) to the left of the current marker
position. If no target is detected, the marker is not moved and the message saying “Not
detected” is displayed (no error occurs). If the marker function is off, executing this
command causes an error and the command is ignored. (No query)
Corresponding
key
[Search] - TARGET - SEARCH LEFT
<numeric>
Description Delay time for each sweep
Range 0 to 30
Initial value 0
Unit s (second)
Resolution 0.001
To Next Page
Loading...
Need help?
General
