Chapter 16 451
GPIB Command Reference
TARR?
16. GPIB
Command Reference
( S - Z , :PROG )
TARR?
Syntax TARR? <numeric 1>
Description Within the waveform analysis range specified with the “ANARANG” command on page
267, searches the analysis range from left to right for a point of the specified measurement
value, and reads out the sweep parameter value at the first detected point. If the specified
measurement parameter value is not detected, 0 is read out.(Query only)
Parameters
If the specified parameter is out of the setting range, an error occurs and the command is
ignored.
Query response {numeric 2}<newline><^END>
Corresponding
key
No front panel key is available to execute this function.
<numeric 1>
Description Measurement parameter value you want to search for
Range -9.9E37 to 9.9E37
Unit Varies depending on the measurement parameter (refer to the
explanation of unit in
“SCAL” on page 423).
{numeric 2}
Description Sweep parameter value of the detected point
Unit Varies depending on the sweep parameter (refer to the explanation
of unit in
“CENT” on page 277).
To Next Page
Loading...
Need help?
General
