Chapter 16 441
GPIB Command Reference
SMKRVAL{1-7}?
16. GPIB
Command Reference
( S - Z , :PROG )
SMKRVAL{1-7}?
Syntax SMKRVAL{1|2|3|4|5|6|7}?
Description For the active trace (set with the “TRAC” command on page 457), reads out the
measurement parameter value at a sub marker (marker number 1-7) position. (Query only)
Query response {numeric}<newline><^END>
If the measurement parameter is a scalar value (for other than COMPLEX Z-Y), the
measurement parameter value is read out. If the measurement parameter is a vector value
(for COMPLEX Z-Y), the readout is as follows:
• If the polar chart format is selected, the amplitude is read out.
• If the complex plane format is selected, resistance (for trace A) or conductance (for
trace B) is read out.
Corresponding
key
No front panel key is available to execute this function.
To Next Page
Loading...
Need help?
General
