Chapter 3 45
Setting Measurement Conditions
Combining Two or More Sweep Conditions (List Sweep)
1. Chapter Title
2. Chapter Title 3. Setting Measurement
4. Chapter Title
5. Chapter Title
Conditions
Deleting a segment
To delete a segment, use the commands given below.
• “SDEL” on page 425
• “CLEL” on page 279
The “SDEL” command deletes a specified segment from the table (if no table is specified,
then he segment to be worked on at the time of executing the command involved). The
“CLEL” command deletes all segments from the table.
Setting the trace color of each segment
To specify the trace color of each segment, use the command given below.
• “SCOL” on page 424
To Next Page
Loading...
Need help?
General
