Agilent Technologies 4294A Programming Manual

Chapter 16 359
GPIB Command Reference
MKRSTAR
16. GPIB
Command Reference
( F - N )
MKRSTAR
Syntax MKRSTAR
Description For the active trace (set with the “TRAC” command on page 457), sets the sweep
parameter value at the marker position as the sweep range start value. To set the start value
of each segment when creating the list sweep table, also use this command. If the marker
function is off, executing this command causes an error and the command is ignored. (No
query)
Corresponding
key
[Marker→] - MKR → START
MKRSTOP
Syntax MKRSTOP
Description For the active trace (set with the “TRAC” command on page 457), sets the sweep
parameter value at the marker position as the sweep range stop value. To set the stop value
of each segment when creating the list sweep table, also use this command. If the marker
function is off, executing this command causes an error and the command is ignored. (No
query)
Corresponding
key
[Marker→] - MKR → STOP
MKRTR
Syntax MKRTR
Description For the active trace (set with the “TRAC” command on page 457), sets the range between
the marker and the Δ marker as the partial search range. If the Δ marker mode is off,
executing this command causes an error and the command is ignored. (No query)
Corresponding
key
[Search] -SEARCH RANGE MENU - MKRΔ → SEARCH RNG
MKRTRMAX
Syntax MKRTRMAX
Description For the active trace (set with the “TRAC” command on page 457), sets the marker position
as the partial search range upper border value. If the marker function is off, executing this
command causes an error and the command is ignored. (No query)
Corresponding
key
[Search] -SEARCH RANGE MENU - MKR → MAXIMUM

Agilent Technologies 4294A Specifications

General

Brand	Agilent Technologies
Model	4294A
Category	Measuring Instruments
Language	English