Chapter 16 419
GPIB Command Reference
SAVDSTA
16. GPIB
Command Reference
( S - Z , :PROG )
SAVDSTA
Syntax SAVDSTA <string>
Description Saves the instrument setting state, calibration data array, compensation data array, and
memory array (refer to
“Internal data arrays” on page 81) into the specified file.
Regardless of the settings with the “SAVCAL”(416page), “SAVDAT”(417page),
“SAVDTRC”(420page), “SAVMEM”(420page) and “SAVMTRC”(421page) commands,
the arrays are saved. When specifying a file, you can use a file name including its extension
(refer to
Table 8-1 on page 113) or a file name whose extension is omitted. If the extension
is not specified, the file name is the specified file name with the “.STA” extension added.
(No query)
Parameters
If the specified file name has characters that exceed the maximum length, only the string of
up to the maximum length is valid and the remaining characters are ignored.
Corresponding
key
[Save] - STATE
SAVDTIF
Syntax SAVDTIF <string>
Description Saves image on the LCD screen into the specified file in the TIF format. When specifying
a file, you can use a file name including its extension (refer to
Table 8-1 on page 113) or a
file name whose extension is omitted. If the extension is not specified, the file name is the
specified file name with the “.TIF” extension added.(No query)
Parameters
If the specified file name has characters that exceed the maximum length, only the string of
up to the maximum length is valid and the remaining characters are ignored.
Corresponding
key
[Save] - GRAPHICS
<string>
Description Save file name
Range When the extension is not specified: 8 characters or less
When the extension is specified: 12 characters or less
<string>
Description Save file name
Range When the extension is not specified: 8 characters or less
When the extension is specified: 12 characters or less
To Next Page
Loading...
Need help?
General
