Agilent Technologies 4294A Programming Manual

Chapter 16 327
GPIB Command Reference
LIMIAMPO
16. GPIB
Command Reference
( F - N )
LIMIAMPO
Syntax LIMIAMPO <numeric>[DEG|RAD|OHM|SIE|H|F|PCT]
LIMIAMPO?
Description For the active trace (set with the “TRAC” command on page 457), sets an offset value of
the limit for the measurement parameter value.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
key
[System] - LIMIT TEST - LIMIT LINE OFFSETS - AMPLITUDE OFFSET
LIMIPRMO
Syntax LIMIPRMO <numeric>[HZ|MHZ|V|A]
LIMIPRMO?
Description For the active trace (set with the “TRAC” command on page 457), sets an offset value of
the limit for the sweep parameter value.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
key
[System] - LIMIT TEST - LIMIT LINE OFFSETS - SWP PARAM OFFSET
<numeric>
Description Offset value for the measurement parameter value
Range -1E9 to 1E9
Initial value 0
Unit Varies depending on the measurement parameter (refer to the
explanation of unit in
“SCAL” on page 423).
<numeric>
Description Offset value for the sweep parameter value
Range -1E9 to 1E9
Initial value 0
Resolution Varies depending on the sweep parameter (refer to the explanation
of resolution in
“CENT” on page 277)

Agilent Technologies 4294A Specifications

General

Brand	Agilent Technologies
Model	4294A
Category	Measuring Instruments
Language	English