Agilent Technologies 4294A Programming Manual

462 Chapter 16
GPIB Command Reference
WIDVTYPE
WIDVTYPE
Syntax WIDVTYPE {DIVS2|MULS2|DIV2|FIXed}
WIDVTYPE?
Description For the active trace (set with the “TRAC” command on page 457), selects the method to set
a cutoff point in the trace bandwidth analysis function.
Parameters
If the measurement parameter is a vector value (for COMPLEX Z-Y), you can select
FIXed only.
Query response {DIVS2|MULS2|DIV2|FIXed}<newline><^END>
Corresponding
key
[Search] - WIDTHS DEF MENU - {MKRVAL/(√2) | MKRVAL*(√2) | MKRVAL/2 |
FIXED VALUE}
WOPEN
Syntax ROPEN <string>
Description If the specified file exists, this command makes it write-enabled; otherwise, creates a new
file and makes it write-enabled. This command takes its arguments in a different way,
depending on the file format.
The size of an existing file cannot be changed. Therefore, if you want to change them,
delete the file itself using the
“PURG”(406page) command and then create a new file using
this command.
This command is used in combination with the “WRITE”(463page) command and the
“CLOSE”(280page) commands, as shown in Figure 16-8 on page 412. (No query)
Parameters
Corresponding
key
No front panel key is available to execute this function.
Description
DIVS2 The value obtained by dividing the measurement parameter value
at the marker position by
is set as the cutoff point.
MULS2 The value obtained by multiplying the measurement parameter
value at the marker position and
is set as the cutoff point.
DIV2 The value obtained by dividing the measurement parameter value
at the marker position by 2 is set as the cutoff point.
FIXed (initial
value)
Lets you set the cutoff point freely using the “WIDFVAL”
command on page 460.
2
2
Description
<string> File name of up to 12 characters including its extention

Agilent Technologies 4294A Specifications

General

Brand	Agilent Technologies
Model	4294A
Category	Measuring Instruments
Language	English