314 Chapter 16
GPIB Command Reference
ESNB
ESNB
Syntax ESNB <numeric>
ESNB?
Description Sets the value of Instrument Event Status Enable Register (Event Status Enable Register
B).
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
key
No front panel key is available to execute this function.
EXPP
Syntax EXPP {ON|OFF|1|0}
EXPP?
Description For the active trace (set with the “TRAC” command on page 457), if the trace
measurement parameter is phase, determines whether to perform the extended phase
display (display in which phases out of the range between -180 and 180 are not rolled up).
If the trace measurement parameter is not phase, executing this command causes an error
and the command is ignored.
Parameters
Query response {1|0}<newline><^END>
Corresponding
key
[Format] - EXP PHASE on OFF
<numeric>
Description Value of Instrument Event Status Enable Register
Range 0 to 65535
Initial value 0
Resolution 1
Description
ON or 1 Enables the extended phase display.
OFF or 0 (initial value) Disables the extended phase display.
To Next Page
Loading...
Need help?
General
