434 Chapter 16
GPIB Command Reference
SEDI
SEDI
Syntax SEDI [<numeric>]
Description In the creation/edit of the list sweep table, starts the edit of the segment specified as the edit
target (set with the
“SEGM” command on page 435). Note that, if a segment is specified,
the edit target segment is changed to the specified segment and then the edit is started.
After the completion of the parameter setting of the segment, execute the “SDON”
command on page 426 to finish the edit work. After executing this command and the
“SADD” command on page 415 (to start segment edit), executing this command, without
executing the “SDON” command, causes an error and the command is ignored.
If the creation/edit of the list sweep table has not been started, executing this command
automatically starts table creation/edit and then starts the edit of the segment. (No query)
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Corresponding
key
[Sweep] - EDIT LIST - EDIT
<numeric>
Description Segment number you want to edit
Range 1 to the number of segments in the list sweep table
Resolution 1
To Next Page
Loading...
Need help?
General
