356 Chapter 16
GPIB Command Reference
MKRO
MKRO
Syntax MKRO {DATA|MEMO}
MKRO?
Description For the active trace (set with the “TRAC” command on page 457), sets the trace on which
you want to use the markers. The displayed traces are the settable trace. Executing this
command to specify a trace not displayed causes an error and the command is ignored.
Parameters
Query response {DATA|MEMO}<newline><^END>
Corresponding
key
[Marker] -MKR [ ]
MKROFS
Syntax MKROFS
Description For the active trace (set with the “TRAC” command on page 457), sets the measurement
parameter value at the marker position to the trace offset value. If the marker function is
off, executing this command causes an error and the command is ignored. (No query)
Corresponding
key
[Marker→] - MKR → OFFSET
Description
DATA (initial value) Specifies the data trace.
MEMO Specifies the memory trace.
To Next Page
Loading...
