Agilent Technologies 4294A - Change 2; Change to the Revision 1.10

472 Appendix A
Manual Changes
Change 2
Change 2
The firmware revision 1.10 and below does not support the following function.
• File Transfer function
Change to the revision 1.10
Chapter 13 , “Application Sample Programs,” on page 185
Delete the following section
• “File Transfer Function” on page 239
Chapter 16 , “GPIB Command Reference,” on page 255
Delete the following commands.
• “CLOSE”(280page)
• “CWD?”(284page)
• “FNAME?”(316page)
• “FNUM?”(316page)
• “FSIZE?”(318page)
• “READ?”(407page)
• “ROPEN”(412page)
• “WOPEN”(462page)
• “WRITE”(463page)