430 Chapter 16
GPIB Command Reference
SEARMAXP
SEARMAXP
Syntax SEARMAXP <numeric>
SEARMAXP?
Description For the marker search function for the active trace (set with the “TRAC” command on page
457), if the partial search is enabled (specified to ON with the “PARS” command on page
395), sets the partial search range upper border value to the specified measurement point.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
key
No front panel key is available to execute this function.
<numeric>
Description Number of the measurement point you want to set to the upper
border value (the number assigned in order from the left edge
assuming that the number of the leftmost measurement point is 1)
Range 1 to the number of points
Initial value number of points
Resolution 1
To Next Page
Loading...
Need help?
General
