428 Chapter 16
GPIB Command Reference
SEANPKR
SEANPKR
Syntax SEANPKR
Description For the active trace (set with the “TRAC” command on page 457), moves the marker to a
peak to the right of the current marker position. If no peak is detected, the message saying
“Not detected” is displayed (no error occurs). If the marker function is off, executing this
command causes an error and the command is ignored. (No query)
Corresponding
key
[Search] - PEAK - NEXT PEAK RIGHT
SEAR
Syntax SEAR
Description For the active trace (set with the “TRAC” command on page 457), moves the marker to the
target (set with the “SEATARG” command on page 433) to the right of the current marker
position. If no target is detected, the message saying “Not detected” is displayed (no error
occurs). If the marker function is off, executing this command causes an error and the
command is ignored. (No query)
Corresponding
key
[Search] - TARGET - SEARCH LIGHT
SEARLINE
Syntax SEARLINE {ON|OFF|1|0}
SEARLINE?
Description For the active trace (set with the “TRAC” command on page 457), enables/disables the
display of the lines indicating the search range at list sweep.
Parameters
Query response {1|0}<newline><^END>
Corresponding
key
[Search] - SEARCH RANGE MENU - RNG LINE on OFF
Description
ON or 1 Enables the display of the lines indicating the search range.
OFF or 0
(initial value)
Disables the display of the lines indicating the search range.
To Next Page
Loading...
Need help?
General
